No official Railway Board PDF has been traced for this entry yet. The text below was read from the document held in the library.
| Type | Commercial Circular |
|---|---|
| Topic | freight |
‘Speed must be resticted to 15 kmph and over heed power must be switched off when the gross
4310 @ Be SLA all all 59% 8
é operating manua... B:
PDF reader
'SSISMIYSYYM corcemed must furnish full particulars of the wagon tothe Cont, such
uring Ry. Type of Wagon, Staton rom and to, route over whichis equred to mov] ()QO%
CContretDsional offen vl give necessary permission to the concerned sia to despatch
pra tain on dato advise and obtain thew acknowledgement
‘A Caution Order wil be given to the Guard and Loco pit ofthe train carrying 000 to rest the speed
‘and observe any other speed restriction at anyother point or other precautions as ai down,
(On Electried Sections:
a
»
°)
4
ही
प्रो
Dy
In ation tothe precautions laid down above, the flowing special precautions must be observed
{or ransport of over-hmensional leads onthe lected section:
In all cases, where oversize consignment is moving, it should be remembered by all staff
‘accompanying the 000. thatthe overhead eleccal equipment is always LIVE™, except when 9
prtcular power block has been obtained from the Tracion Power Cortrller. Even when a power
block has boon obtained, i should be remembered that al te ines, othe than those for which the
‘power block has been granted, are LIVE" at 25000 Volts.
[No person should climb on the root of cariages of wagons. when those vehicles at
‘beneath the overhead equipment, except when the equipment is made DEAD’ and earthed,
०८०००
‘The following are the prescribed dearance fom contact wires for he passage of ever-dimensional
‘oads trough elected tacton areas and the specal esictons fequred
‘Special speed restction is nt required when the gross clearance i atleast 390 mm.
‘Speed must be restricted 10 15 kmph, when the gress clearance is in between 390 mm to 340 mm.
‘Speed must be resticted to 15 kmph and over heed power must be switched off when the gross
clearance i less than 340 mm
‘No consignment with less than 100 mm grass clearance from the over head contact wire wil be
permitted over elected section.
‘A representative ofthe Tracton Department should also accompany all ODC having lesrance as
‘spectie in tem (0) and (दे 0 sub para (3) above, over elected section.
‘A representative of the Tracton Department should accompany all ODC toads having width of
‘mare than 1961 mm fr BG and 1510 mm for MG trom the corte line of he rack
‘Section Controlers and Traction Power Controller must co-ordinate, while an ODC maves on
elected ae,
‘list of structures, where the clearances are restciad on the electric wacton area and also the
Clearance avaiable Under verdes should be with the Section Controllers and Traction Power
Contaters.
Despatch of 0005:
{AL the criginating station the (000 wagen wil be moved when final approval has bean obtained
{rom te compatent authority
{At the originating point the number of wagon/wagons carrying ODC shouldbe entered by the Train
CClerk’SMtin the vehice guidance in red ink tobe handed over tothe Guard ofthe wan
‘SSISM should advise the Section Controle on duty, before starting the tain and while asking ine
lear, describe the vain number with eter %'sulxed on
॥ wil ७७ the duty ofthe Dy. Chief Controle to keep adjoining Control Office informed about the
‘mavement of such ODC. til such time, its handed aver to the adjoining dvson by specified tain
‘Also ensure that the consignment is moved sty by the authorised rout,
‘Shurting of rain wth an ODC should be avoided. Loose and rough shunting of 000 wagon and
‘against such wagon fs peohibied
\when any 000 wagon is detached from the” at any station, SM and Guard are responsible to
‘ensure safe placement and securing ow
Fact or accompanying करी लि बन... दौर an should be povided so vequied
Wren 21०54 5 slong hatitcan, ___ammodaled in to tucks (eto 8 wheeler),
4 must be taded in tee tucks so Mat the enue wai scared! onthe cate vehicle are the
ford tucks are idler. The load must be placed on packing inthe cere tuck, so that itis clear of
the floor ofthe end incks by not less 152 mm and there must not be less than 304 mm up sie
III
Extract shown above; the full text is available in the search app.
Open this circular in the search app · Search all 4,025 documents